Wellcraft V20 Community

Go Back   Wellcraft V20 Community > Wellcraft V-20 Forums > Repairs
Register FAQ Community Calendar Today's Posts Search

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #15  
Unread 04-03-2016, 12:31 AM
smokeonthewater's Avatar
smokeonthewater smokeonthewater is offline
God
 
Join Date: Oct 2011
Location: Indiana near louisville Ky
Posts: 1,814
Default

Yup open the drains and poke a peice of wire in each one to clear any rust scale (good flow of water draining)
Then pull the lower hose from the water pump n dump it....
Last it's not a bad idea to pull a hose off the power steering cooler...

Finally make sure to store the outdrive in the down position so the exhaust cavity can't hold water

Sounds like a lot but only takes 15-20 minutes once you figure it out.

EDIT: the above assumes raw water cooling.... If you have closed cooling then you only drain the manifolds/risers, raw water side of the heat exchanger, and the power steering cooler

Last edited by smokeonthewater; 04-03-2016 at 12:36 AM.
Reply With Quote
 


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 09:00 PM.


Powered by vBulletin® Version 3.8.2
Copyright ©2000 - 2026, Jelsoft Enterprises Ltd.