2 Inch ball, I'm guessing at 1 1/16-1 3/8 tapered bearing set(most common size). I don't know exactly where the trailer will be in the next couple weeks due to me moving out of my shop, but just map quest to Goose Creek, SC 29445. If you drive this far, I'll make sure the lights work, Those rollers do set the boat high, I was going to remove the rollers, save the pivot brackets, and install 2X6 carpeted bunks. That should lower the boat by a few inches. I've done this swap before on similar trailers with good luck. The tires hold air and look decent, but I'd replace them with new if I were taking long trips with a boat on it.
|
12-01-2015, 08:00 AM
Threaded Mode