|
|
|
|
#1
|
||||
|
||||
great to have another member south of I-10.. not sure, does the 78 have a 20 or 25 inch transom, also doesn't that deck drain into the bilge. if so, might want to raise deck to drain overboard. is your gas tank under the deck or saddle tanks?
adding the bracket & swim platform will be a big job alone. might be quicker to look for a newer hull with a blown sea drive set up. these are usually mid 80's with below deck fuel tanks, raised deck, and transom already closed. what ever u do lots of knowledge on here. and we like pictures. 
|
|
#2
12-10-2016, 02:27 PM
|
|||
|
|||
|
Phatdaddy, sorry for taking so long to reply. I have not been on the forum in a long time. My transom is 25". My floor drains into the splash well. I currently have a Johnson 150 and she runs out great. Recently I was cleaning the boat and found 2 cycle oil in the bottom of the hull. Upon investigation and pulling the fuel tank, I found several holes in the bottom of my original aluminum tank. Fuel finally worked its way through the expanded foam surrounding my tank and started draining back. I am currently prepping to remove top cap and replace stringers and bulkheads that I found rotted when I pulled the fuel tank out.I will replace the transom as well. Going back with a poly tank. I am going to do some customizing while I have everything apart. Adding a 30" motor extension and getting rid of my splash well. Moving my center console forward as well. Going to be adding about five feet of space in the back of the boat for fishing and diving conveneance.
|
|
#4
12-10-2016, 09:22 PM
|
|||
|
|||
|
Thanks for the info. I already have a poly tank that was given to me. It came out of a wrecked boat. Boat was run hard into a dock and destroyed the port bow area.i have a few pics of my v20 so far and will be taking more throughout the rebuild process. I am hoping things work out and get the top cap off tomorrow.
|
|
#6
12-11-2016, 05:20 AM
|
|||
|
|||
|
I'm very interested in seeing pictures of the stringer setup once you get the top cap pulled. I'd also like to see pictures of the underside of the top cap if you can get them.
My 1977 V-20 Center Console will probably need stringers replaced in the near future also and the floor needs some work for a couple of soft spots behind the center console.
__________________
1973 Mako 20' Center Console 1984 Wellcraft V20 Cuddy 1977 Wellcraft V20 Center Console 1975 Wellcraft V17 Center Console 1964 16' Super Skeeter with 55Lb thrust Motorguide Trolling Motor 1985 Glastron HPV-175 - sold 1984 Wellcraft 180 Fisherman - sold 1973 Mako 17' Angler - sold 1972 Mako 17' Standard - sold 1972 Mako 19' Center Console - sold Always looking for the next one.
|
|
#7
12-14-2016, 07:47 PM
|
|||
|
|||
|
Redloon, I got the top cap off Sunday and sitting on saw horses. Waiting for weather to clear up to get some good pictures. I will post them later. Do you have the bench seats/storage on both sides of the bow or do you have the raised deck in bow area? I have the seats on each side of the bow. I have several spots on the floor that are soft as well. Most of the area behind the console is soft. Especially around the helm seat. After removing top cap and further inspection of the stringers and bulkheads, I found all of the bulkheads are rotted and very little wood in the stringers. Most of the floor is rotted too. Good luck with yours.
Last edited by Fldivebum; 12-14-2016 at 08:11 PM.
|
 |
|
|
Hybrid Mode
