Things are progressing nicely, now that I'm paying more attention to detail, ha-ha. Need to do a bit of brainstorming tho. The next section to do is the main (front) section of the bow. As stated before it's about 80"w x 40" at centre line. Going to make a one piece template tomorrow and see if it fits thru the sliding hatch.
Any ideas if it doesn't? I know I can put it up in pieces, but then I've got to lay the skin on from up-side down, probably also in pieces. Exactly what I hope to avoid. All and any idea's welcome. Thanks
Earl
|
09-11-2015, 03:37 PM
Threaded Mode