|
|
|
|
#1
|
||||
|
||||
personally I would zip out a few screws and raise the cap in one piece.... much less glass work and no worries about trying to match old gelcoat
|
|
#2
12-09-2014, 10:44 PM
|
||||
|
||||
|
Quote:
__________________
1999 Wellcraft 22WA-200 Ocean Runner 1982 Grady White Tarpon 190-110 Evinrude-Sold 1996 Striper 2100WA-RIP Sandy 1989 Wellcraft 18-Sport-125 Force-sold
|
|
#3
01-10-2015, 07:27 AM
|
||||
|
||||
|
Still haven't started yet. Hopefully I'll drag the boat over to my job in the next few weeks and start cutting and cleaning out the old transom so ill be ready to go in the spring.
__________________
1999 Wellcraft 22WA-200 Ocean Runner 1982 Grady White Tarpon 190-110 Evinrude-Sold 1996 Striper 2100WA-RIP Sandy 1989 Wellcraft 18-Sport-125 Force-sold
|
|
#5
06-01-2015, 09:05 PM
|
||||
|
||||
|
I finally got my wellcraft down to the marina and used it a few times so now it's time to move back onto this boat. I should be cutting the cap off the rear of the boat some time this week. I'll post some pics when I begin.
__________________
1999 Wellcraft 22WA-200 Ocean Runner 1982 Grady White Tarpon 190-110 Evinrude-Sold 1996 Striper 2100WA-RIP Sandy 1989 Wellcraft 18-Sport-125 Force-sold
|
|
#6
06-06-2015, 02:21 PM
|
||||
|
||||
|
Finally started cutting into it today. I got the cap off and I'm getting ready to cut the floor.
__________________
1999 Wellcraft 22WA-200 Ocean Runner 1982 Grady White Tarpon 190-110 Evinrude-Sold 1996 Striper 2100WA-RIP Sandy 1989 Wellcraft 18-Sport-125 Force-sold
|
|
#7
06-06-2015, 05:40 PM
|
||||
|
||||
|
Floor is out. Stringers look good but transom is mush, comes out nice and easy so far. Need to make a little dust tomorrow to get the edges out.
__________________
1999 Wellcraft 22WA-200 Ocean Runner 1982 Grady White Tarpon 190-110 Evinrude-Sold 1996 Striper 2100WA-RIP Sandy 1989 Wellcraft 18-Sport-125 Force-sold Last edited by Striper80; 06-06-2015 at 05:50 PM.
|
 |
|
|
Hybrid Mode
