|
|
#3
10-16-2014, 11:13 AM
|
||||
|
||||
http://www.bobsmachine.com/
http://www.thmarine.com/products/Out...ic-jack-plates  I finally replaced a solenoid on the 18 year old Bob's Hydraulic Jack Plate (original was still pulling closed but would not deliver any current through the contactor). It is a direct match to the old style Mercury trim pump solenoids of which I have extras in a box on a shelf. Happy Happy. If someone only made a switch that could hold up to the Florida sun, salt spray, etc. I think I replaced the switch 3 times in 18 years.
__________________
 1996 -19' NV Flats 115 Mercury 4-stroke 1983 -20' Wellcraft Center Console 250 XS Last edited by RidgeRunner; 10-17-2014 at 02:00 PM. 
|
|
|
Threaded Mode