|
|
#21
|
|||
|
|||
I pumped the bulb with no results ,phat
__________________
1988 Grady White Seafarer Yamaha 250 ox66 on a bracket 
|
|
#22
07-25-2014, 11:00 AM
|
||||
|
||||
|
Just because you have a new VRO pump, doesn't mean you have a working VRO pump. I chased this same problem before on an engine with a new pump, ended up being the pump was bad out of the box. Get a fuel pressure gauge on it and see if it is holding pressure when it does it. I know this VRO pump when it messed up would block the fuel flow so I couldn't even get fuel to it by pumping the primer bulb. I had to use a hammer to hit the pump to get it to pop open and allow fuel to flow so I could get back to the ramp.
__________________
2011 SUNDANCE B20CCR SKIFF, 2011 YAMAHA 90HP 4 STROKE, 2011 KARAVAN SINGLE AXLE ALUMINUM TRAILER, LOWRANCE ELITE-7 HDI, MINN KOTA RIPTIDE TROLLING MOTOR 2000CC HYDRA-SPORT 225+HP EVINRUDE SOLD  AND THE PINK JEEP!!!! R.I.P. http://www.wellcraftv20.com/communit...ad.php?t=11664 
|
|
#23
08-08-2014, 07:17 AM
|
|||
|
|||
|
Ferm, what you said about just because its new made me think ! long story short. I think I have the answer .The fuel line had a split in it. Not even sure how this happened considering that its not old at all . Replaced it and seems to have solved the problem. Thanks,
__________________
1988 Grady White Seafarer Yamaha 250 ox66 on a bracket
|
 |
|
|
Linear Mode
