|
|
#9
06-12-2014, 12:59 PM
|
||||
|
||||
my .02 about rodholders....
I frequently have had to cut two holes to install an angled rodholder or outrigger base. If youve ever tried to use a holesaw to create hole #2 that overlays hole #1 its very tricky. Take a dremel tool and use the 60grit sandin drum to edge out a larger hole. This thing eats through fiberglass like a fat man on 10cent wing night. After using this tool and bit the first time I was amazed. Did the same thing when I created new speaker holes. Its dusty but it works like a champ!!
__________________
- The charm of fishing is that it is the pursuit of what is elusive but obtainable, a perpetual series of occasions for hope. Lucky Jack - .......The Surprise is not old; no one would call her old. She has a bluff bow, lovely lines. She's a fine seaboat: weatherly, stiff and fast, very fast, if she's well handled. No, she's not old; she's in her prime. 85' Wellcraft 20 Fisherman "Guale Girl" 1979 Alumnacraft 14 - STILL got holes in it 2006 WS Tarpon160f - "Mudd Butt" 
|
|
|
Threaded Mode