Ready to Fish

[RidgeRunner]

Nice looking piece of hardware you found there. I am just before cutting the holes in the gunnels for the flush mount ss rod holders. Cheap ones, but at least they are all stainless and the flange is cast and welded to the tube. Having them face straight back just isn't the best case scenario is it?
Then there are the outriggers. I have the Perko bases for the small poles but the only decent poles I have are the Lee's 15' aluminum poles that are the larger diameter. None of the sizes are adaptable, even if I take off the largest section I can't get the diameters to match up.. So I go buy more stuff to make it work? No. I am not $pending another grand on the lift and lay t-top mounts, I never much used them.. I want a bimini over the foredeck, a cushion for the casting platform and some graphics on the hull.
I did install the small Nicro utility hooks to help get some stuff organized.
I will post a picture up soon as I take the plunge..

Very nice looking V. I like the blue hull sides a lot.