many questions about repairing/replacing stringers

[carboncow]

Originally Posted by dan4836

I am using 3/4 A/C plywood with two coats of poly resin to seal it. After I install the plywood stringers into the existing cavity, I will laminate with 1708 and cap the top off with CSM.

I will be doing most of this work tomorrow so I will post some photos.

Dan,

We are going to use 3/4 AC too. We found all our bulkheads are mush too...so lots of cutting and reinstalling todo yet.

When you guys lay the 1708 on the deck...will you but the glass sheets to one another or will you over lap them...or some other technique? We are going to be using a textured paint when done so small imperfects will not bug us but we are still trying to figure out all the ways to terminate.