I went over to the dark side

[captpete13]

the sticker on the motor says it weighs 517lbs. But the Mercury factory service manual says 460 something if I remember right. My old Yamaha is probably 430 ish. I'm gonna sell the Yammie. Included will be an extra gearcase, clamp bracket, tach, key switch, oil tank, and all wiring. Check the classified section in a few minutes.

[lathehand]

The only thing that could be nicer with that rig would be that it were mine

[willy]

Congrats Pete that black color will look great with your hull

[reelapeelin]

Originally Posted by captpete13

the sticker on the motor says it weighs 517lbs. But the Mercury factory service manual says 460 something if I remember right. My old Yamaha is probably 430 ish. I'm gonna sell the Yammie. Included will be an extra gearcase, clamp bracket, tach, key switch, oil tank, and all wiring. Check the classified section in a few minutes.

I blink for a minute and WOW!!...Spongey sportin' a freakin' 225 OPTI!!...I would think she's a lil stronger than the 225 Yam and I KNOW she'll burn less fuel!!...those Optis are STRONG motors, but good on fuel!...Nicks 28' cat w/twin 200s used to run 60 miles out, troll all day and back in on 90 gals...NOBODY was doin' that at the time.

Yer gonna love that!!...

[captpete13]

well so far so good. I launched the boat Saturday. I started with the same prop I used with the 225 Yamaha. A 19" Laser. I ended up at 46 knots hitting the rev limiter. Today I tried a 19" revolution 4. The cruise rpm's were better but it was too rough to open it up. Maybe tomorrow. Your right Ozzie the fuel consumption is good. About the same as the old 150.

[spareparts]

that motor should have enough torque to spin up a mirage(I'd guess 21P), unless you need the bow lift that laser is giving you

[RidgeRunner]

Originally Posted by spareparts

that motor should have enough torque to spin up a mirage(I'd guess 21P), unless you need the bow lift that laser is giving you

I agree. The XS250 puts the 21 Thunderbolt (Mirage without the vent holes)on the limiter relatively easy even with 4 people on board. It is a little slower on top than the Tempest but a better cruising prop IMO.

[captpete13]

I started with the Laser only because it's what I had with the 225 Yamaha. The rev 4 had a great cruise and a top end of 45 kts and 5600 or so rpms. I might fool around some more with props as I find them on customer's boats at my marina. I think I can get ahold of a 21 Mirage and a 21 Tempest.

[reelapeelin]

Originally Posted by captpete13

I started with the Laser only because it's what I had with the 225 Yamaha. The rev 4 had a great cruise and a top end of 45 kts and 5600 or so rpms. I might fool around some more with props as I find them on customer's boats at my marina. I think I can get ahold of a 21 Mirage and a 21 Tempest.

A Mirage on my Honda hit ALL the numbers...except it was haevy and created a slight rattle in the lower unit at idle speed...dropped down 1/4" dia on Power Tech prop w/same specs as the Mirage and BINGO...kept all the numbers and rattle gone...considering the store you get to shop from, I know you'll come across Mr RIGHT pretty soon...

Has the extra weight shown up anywhere?