![]() |
|
#11
|
||||
|
||||
|
Tether the stern to a solid anchor point. Pull the trailer out with your tow vehicle about two foot. Block the stern up and pull the trailer out about 3/4 of the way. Now jack it off the trailer and block it and pull your trailer on out.
__________________
1983 V-20 capsized. . . . in the garage. |
|
#12
|
||||
|
||||
|
a hammer drill and a tapcon can make for a solid anchor point in concrete in short order
|
|
#13
|
|||
|
|||
|
Its not too bad. I did it about like bksah2. Blocked up the keel and the chines on the stern and the keel about middle way down the hull and pulled the trailer out by hand.
__________________
77 V20 cuddy with 170 I/O Mercruiser 72 16ft. Carolina w/a 25hp Evinrude |
|
#14
|
||||
|
||||
|
Go back to my thread when I replaced my inbd. I have truss's and what I did was put a 2x4 on either side of the bottom (horizontial) part of the truss and then put a vertical brace on either side of the boat from the floor to the bottom of the truss, lifted my 350 out with no trouble and I bet it would have lifted the boat eng and all.
Do a search under me or "repowering" I have pics of the whole thing and some close up of my bracing.
__________________
Tis better to be quiet and thought a fool than open your mouth and prove it!! 1991 V-20 cuddy I/O 350 volvo duo prop, 1998 15ft Grumman 9.9 Johnson
Last edited by garagenc; 12-31-2012 at 04:11 PM. |
|
#15
|
||||
|
||||
|
Quote:
__________________
1987 V20 w/1987 150HP Yamaha on a Shoreland'r Trailer 1978 16.5 Airslot w/1996 120HP Force on a Four Winns trailer 1996 V21 w/1993 200HP Mercury on a Shoreline Trailer All towed by a 5.7L Hemi Durango. If God didn't have a purpose for us we wouldn't be here, so Live simply, Love generously, Care deeply, Speak kindly. (Leave the rest to God) ![]() Silence, in the face of evil, is itself evil. Not to speak is to speak, not to act is to act. God will not hold us guiltless. |
|
#16
|
||||
|
||||
|
same here i was going to do it out side but now that i seen it done im doing it in my garage give me time and comfort to get all that paint of the bottom here is some pics of the room i have to do it and i have a large beam there to hook up the *** end dont no why i didnt think of it before
|
|
#17
|
||||
|
||||
|
|
#18
|
||||
|
||||
|
|
#19
|
||||
|
||||
|
I like Skools idea too. But my garage is lucky to support itself, much less a V20. I am kicking myself for not replacing my rotted 4x4 roof supports and poles with a 3-layered 2x12 beam. When I roll the V out to flip it upright again I might upgrade my roof supports.
__________________
1983 V-20 capsized. . . . in the garage. |
![]() |
|
|