Need Advice

[Kracker Jack]

Like schools said grind the gell coat off to see what your dealing with.dont grind to deep into the glass,just feather the grinder to get rid of the gellcoat and then asess . I have numerous spots on my bottom that the previous owner repaired that im grinding all down and repairing over just to give me a sense of knowing the repair was done correctly.

send us some more pics of the damaged area before and after you grind it down. any soft spots on the floor? Gellcoat cracks in the cockpit or on the bottom that could give us the assumption that the stringers are flexing due to rot? Not trying to be negative but my transom seem pretty solid but when i cut into her she was SHOT!!! So do a couple test pilot holes with a small drill bit to see what consistency the material is being drilled out is, meaning long dry wood shavings are a good sign and "dirt" or wet material means theres rot.remove some screws and see if any water weeps out of the holes.