|
|
#15
03-27-2012, 04:20 AM
|
||||
|
||||
I did mine just like Awthacker did his....my first fiberglass job too....came out well. You can seal the edeges of the hole after you cut them. I woulld think you wouldnt want to mess with lining them up while you are trying to set the two pieces together....
The only other tip I got from here (I think it was ridgerunner) was to put plastic under the holes in your hatch skin because if you get some resin to squeeze out around the hole you could glue your new core to your work surface.
__________________
1986 V-20 1986 Yamaha 150 HP 
|
|
|
Threaded Mode