Boyesen reed valves

[RidgeRunner]

Can't judge a book by the cover Builder. LOL. Anyone that has ever been there to pick up their reeds was probably thinking the same thing. Unsuspecting little place. Normally has a go fast or two and a couple relics sitting out front of his place.

Sorry in advance for the derail..
Reel, when I was checking into my idle issue with the 2.4L I was chasing carburetion, ignition and then checked the reeds to make sure that wasn't it. I did find a coil that was intermittently failing at idle. Found it at the lake, backed into the water with the timing light. Ran very good after replacement. When the motor came off the boat to install big bertha it was running like a champ, save for a leaky trim pump.
Whatever it is doing now may have no bearing on the reeds. But then again it might. To run good one outing and poorly the next is crazy.
Restart problems?? Never. Might be idled too low. Try the warm up lever and see if it starts easier.
Spare, it sounds like I have already jinxed it. Yes it has the plastic coated reed blocks. I was running what I had at the time. I wonder what ethanol does to plastic reed blocks?? S T.