ridge runner tell us how you cut the aft fishbox/well out on your center console. i think i will do the same soon. is there any structural issues if the bottom is removed? does it need to be beefed up so you can walk on/near that area if its cutout? what did you use to cut it with and where did you cut it. were you able to remove the tub part as one piece or did you have to cut it into smaller peices. is there any importtant boat stuff if i start cutting with a grinder about 1" from the bottom of the lip under the lid? Would it be a be a good place for batteries?
|
09-04-2011, 09:19 PM
Threaded Mode