Got fish box cover apart and found out it was cored with 1/2" plywood squares. I have a piece of pressure treated 1/2" that has been dying in my shop for 3 years that I am going to use for that and now I am thinking that the gas tank hatch will get that also and just laminate one or 2 more layers of glass to make up the difference in thickness. Skools, there is no local boat builder here in the mountains of VA so I can"t get the deal you get on resin. Also I thought I would use epoxy resin because of the better adhesion properties would make a stronger fish box cover as I was able to save both upper and lower halfs. So basically I am just glueing that back together with a piece of plywood in the middle. thanks for any suggestions.
|
08-19-2011, 10:45 AM
Threaded Mode