trim motor

[the daydreamer]

worked on the tabs today. found a blown 20 amp fuse under console. replaced fues then could here motor run.(tabs are bennett hydraulic) fluid in pump seemed low so toped it off and ran tabs up and down about 8 or 10 times started to work.i think they had air in them. topped off fluid again and ran them up and down several times. now seem to be working. did not get to run her today as bad thunder storm came up. so will try to test out this week, i hope this will take care of the problem. now if i could just figure out the depth/fish finder i would be good!!!!!!