|
|
#1
|
|||
|
|||
Helm Seat Replacement ??
I finally got sick of the bruises on the back of my legs from the orginal helm seat. I received my new Todd single leaning post today. I've got a couple of questions now that it's time for he swap. How is the original seat post mounted? I had the 1st bolt come right out but the rest just spun. Will I need to cut in a hatch? Are the nuts on the bolts spinning? or is there a plate under there? Thanks
|
|
#2
04-20-2011, 11:39 PM
|
||||
|
||||
|
Quote:
Thanks D
__________________
1987 V20 w/1987 150HP Yamaha on a Shoreland'r Trailer 1978 16.5 Airslot w/1996 120HP Force on a Four Winns trailer 1996 V21 w/1993 200HP Mercury on a Shoreline Trailer All towed by a 5.7L Hemi Durango. If God didn't have a purpose for us we wouldn't be here, so Live simply, Love generously, Care deeply, Speak kindly. (Leave the rest to God)  Silence, in the face of evil, is itself evil. Not to speak is to speak, not to act is to act. God will not hold us guiltless.
|
|
#3
04-21-2011, 08:47 AM
|
||||
|
||||
|
Good suggestion Destroyer.....to answer your question mine did the same thing. Not sure if the pedestal was originally through bolted and then boat assembled or what but mine were spinning....I drilled the heads off and let the bolts fall into the abyss never to be seen again and then filled the holes and rotated my new base and drilled new holes and used them fancy snap togglers that have been mentioned on here a bunch of times.
__________________
1986 V-20 1986 Yamaha 150 HP
|
|
#4
04-21-2011, 09:14 AM
|
||||
|
||||
|
Quote:
Rob's right on the money!!...That's about the way it'll go...togglers...and be sure you SEAL any new core wood that you expose when drilling new holes...pics of the job if you can... 
__________________
'74 V-20/ BF 150 '95 V-21/ BF 150 '84 V-20/ 200 2.4 Merc '87 V-20/'18 F150 Yamaha 
|
|
#5
04-22-2011, 03:32 PM
|
|||
|
|||
|
I have a seat that might work well in the v20 . . . might look a little funny, but I think it would be very functional.
   
|
 |
|
|
Linear Mode
