|
|
|
|
#1
|
||||
|
||||
I have them on my boat. I installed them last year and they work great. It keeps the anchor at the ready and keeps it out from under my feet. I have the one in Rwilson's link with the bottom part of that picture facing the bow. I think you will like it a lot once you do it.
__________________
1987 V20 1996 Jonhson 150 OceanRunner 
|
|
#2
04-20-2011, 02:25 PM
|
|||
|
|||
|
Thanks for the Info. I went to install the chocks last night and either they wont work on my anchor or Im doing it wrong. I mounted the chocks on my work bench to get the layout but when I put the points of the anchor into the cups the flat area in the middle of the anchor wont fit into the plate with the grove unless i make it very loose, inwhich case the anchor will just come out. Also the part of the chock that holds the end of the anchor where the chain hooks on has a bolt in it, is the bolt supposed to go through the hole in the anchor where the chain is attached?
For something so simple this is a pain in the...
|
|
#3
04-20-2011, 03:00 PM
|
||||
|
||||
|
yea the parts were the two tips of the anchor goes on yours being like caps is what has me confused. on mine the flat section of the anchor slides into the holder and the ones for the tips are open on top and the tips just lay in there and they keep them from moving side to side....I can see why you are having problems. post up some close up pics.
__________________
1986 V-20 1986 Yamaha 150 HP
|
 |
|
|
Hybrid Mode
