|
|
#1
|
||||
|
||||
Adding temp gauge
As you guys may recall, I stripped my V down completely. Replacing the dash, I decided to go only with a tach and a water temp gauge. I picked up inexpensive teleflex models at west marine. The instructions for the temp gauge are not very thorough. While I understand ground, ignition, and light... what wire do I connect the the S terminal?
I think I have the tach correct - purple to I, black to G, grey to S - all coming in via a harness from the throttle control box. 1994 Evinrude 175HP, by the way. Thanks, Aaron 
|
|
#2
02-27-2011, 09:39 AM
|
||||
|
||||
|
your tach wiring is correct. As for the temp sender you will probably have to buy a sender and install it to one of the cylinder heads. then run your wire to it.
__________________
1981 V20 cuddy 2007 225 optimax http://budgetboattowing.com/ http://www.gardenstateyachtsales.com/
|
|
#3
02-27-2011, 09:39 AM
|
||||
|
||||
|
tan to s(sender) wire on temp, tan with ablue stripe to alarm or light.
|
|
#4
03-07-2011, 08:35 PM
|
|||
|
|||
|
so the tan wire that goes to the alarm will work for a temp guage?
I want to add one for mine.
|
|
#5
03-07-2011, 08:39 PM
|
||||
|
||||
|
alarm should be tan with a blue stripe
|
|
#6
03-07-2011, 10:02 PM
|
||||
|
||||
|
Forgot to say thanks, Spare. Haven't got it fixed yet, but at least I have a plan.
|
 |
|
|
Linear Mode
