1987 140 v4, Jetting Question and clarification please !!

[nymack66]

Originally Posted by Skools Out

you need all jets same for every cylinder or you'll loose one of your cylinders from leaning out.

my mains are all 62

the low is 16

the high is 56

i'll recheck the jet sizes. that's on a 1988 J/E 140

I am confuse please see attach clip it shows for the intermediates .16 for Starboard and .20 for port
The confusion or its me just over analyzing? I installed the .16 on the Starboard side .20 on Port side as instructed in my manual I may be right or I may be wrong just wanting to be sure ....
Do I install the jets base on cylinders location or port and starboard in regards to Boat ? remember the port carbs feeds the starboard cylinders and the starboard carbs feeds the port cylinders...I see this stuff posted on various sites with no clear answer, they have to have an engineering fact in there somewhere I hope, bare in mind its the same bunch of engineering genius at BRP who figured plastic carbs was the wave of the future:) Just ask Destroyer !