|
|
#7
08-30-2010, 05:11 PM
|
||||
|
||||
The spindles are junk. Both sides fried. The carnage.
Trailer Bearings 002.jpg Trailer Bearings 004.jpg Trailer Bearings 005.jpg No sign of any bearings only the races left on the hubs. Grabbed the tires on the good axle and there is no preload on the bearings, too loose. On the bright side, the tire/wheel/hub assembly was easy to remove, no tools required... I was lucky not to lose a wheel. Fuzzy pic nearly captures the deep groove where the inner race was working on it. Last edited by RidgeRunner; 08-30-2010 at 05:20 PM. 
|
|
|
Threaded Mode