nymack66
Thanks for in info, I have both companys on my list to contact for supplies. I am going to try and do the stringers one at a time so I will have the other to use for Measurements. I am also going to do a scale grid on paper with every measurement I can take before I cut anything. I have never done a project like this before so taking my time not to make things worse. I also have a good friend who will be helping me on the harder parts, We call him doc AKA Buckey he helped build the molds for ROS boats out of Westport, MA so it's not his first rodeo so to speek of. I am doing the hard labor and getting advice and how to from him. I might bring the boat over to his shop when it comes time to do the transon and stringers. I will see how it goes if I get over my head I have a backup plan in place if needed. Now only if the rain will stop so I can get back to work I was going to try and fit the boat in the shop but then the my 72, 340 duster goes outside and I dont see me doing that I have way to much time and money into it to make her spend the night outside...
Mike
|
08-25-2010, 02:16 PM
Threaded Mode