|
|
#2
08-17-2010, 04:52 PM
|
||||
|
||||
Use some Mouse Milk LOL
the grease fitting in on the mounting bracket shown in this picture, look at part 25, thats were the rod is and there should be one or two fittings on there. Maybe they broke off?? look for the hole, might have to drill out and put new grease fittings?? http://i267.photobucket.com/albums/i...RTBracket1.jpg Someone else here had same problem a while back, keep spraying with WD 40, and turning it to work in, can put some heat to it (not a lot) and keep working it will melt the old hard grease and get things moving again, Then when all lose put some new grease in and keep it greased you will be fine!! O yea take the cable off when doing this and turn by hand not to hurt the the helm. Let us know how you make out
__________________
1986 V20  Old Fishermen never die, we just SMELL that way!! 
|
|
|
Threaded Mode