|
|
#8
07-02-2010, 09:11 AM
|
|||
|
|||
ThEFERMANATOR you're my hero
 Thank you, thank you! I re-read your posts and went back to the motor. As you suggested I held the sleeve with the pliers and pushed out the piston with a wood dowel, it took some force, that little sucker was stuck in there big time. Here's the sleeve out:  If I understand you right, The sleeve is supposed to be mounted like this, right? As you stated above, since I don't run the VRO I can remove the little oil plastic piston and get rid of my problem, should I remove the sleeve too? Thanks you for your immensely for sharing your knowledge. Joe
__________________
Life is composed of a bunch of little nothings! Sea Ray 19.5 I/O 351 Cleveland - SOLD 1989 V20 CC 1998 150 Ocean Runner - SOLD Last edited by bassarama; 07-02-2010 at 12:45 PM. 
|
|
|
Threaded Mode