|
|
#11
08-05-2009, 04:11 AM
|
|||
|
|||
I had never done anything like this before i had started this FEB. I did a lot of looking around on the internet and sifted through various sights. Everything has been done with West System. (have acesss to port supply acount and have a friend who works there) I make hardly any money and all of it i make has gone into this project. ( my girlfriend bought the motor....shhhh ) I am 23 years old and i have done all the work at my dads house with little help but from my girlfriend.
I placed the stringers onto the hull with west system and 403 additive. Its great for filleting. I put a bead onto the hull in a couple small places and let it set up. (the stuff is strong as mess) As for the foam. This is the most biased thing i have researched. I bought 2 quart urethane 2lb density kit from west marine just to mess with it. i decided to put it in one of the voids on the starboard side. Well the whole kit didnt even fill the void all the way and it was a pain in the but. i dont have a covered work place, nor a cover so the weather has been a huge factor. Any time it has rained and wood was exposed i let it dry out a long time before i thought of glassing it. I am worried about the foam holding water. I have a drain system made into the side bulkheads but it is useless once i pour the foam in. Feel free to pick me apart on this stuff because this is one area where i have been on all sides of the fence. I wish i could use the old floor as it is in pretty good shape. Only thing is the previous owner sprayed rhino liner in a puke green color onto it and it WILL NOT COME OFF! I am going to lay a new floor down, one layer of 1208 underside and probably 2 layers on top. Sorry if there are any typos, im eatin breakfast while typin and gettin ready for work. Keep the questions coming. I like being picked apart because everything i learned has been within the last year. i am by no means an expert. 
|
|
|
Threaded Mode