Quote:
Originally Posted by phatdaddy
looks good, did you put cloth over the new foam supports, or just coat with epoxy? i have a feeling i am due for the same type project in the future....
|
No I didn't use any cloth, after cutting the supports to fit I just used epoxy to seal the foam cuts to stop any absorbtion. I also coated the entire tank compartment with epoxy while I was in there. The form supports were also stops for the additional foam pour to stop the foam from running into the center channels, creating the corner supports. The foam when poured along the sides will run under the tank filling the corners under the tank and rising up the sides to provide more support from underneath, along with closing the corners on the side locking the tank in place. This was not my idea, I had copied some of the other members ideas that had done this type of replacement before..
Tommy
07-09-2009, 01:07 PM
Threaded Mode