|
|
#1
|
|||
|
|||
Bow Rail Fittings
I just posted in another old thread but it was in the classified section so i don't know that anyone will see it...
I need to replace the bottom fittings on my boat's bow rail, there are 6 fittings total, are the two fittings on either end of the rail 30* and the the 4 others all 60*? And is the tubing 7/8"? Thanks. 
|
|
#2
04-10-2009, 11:54 PM
|
||||
|
||||
|
Tubing 7/8 yes, fittings not sure, but just take them off and go down and match them up you will be fine.
I pulled my rail off as there was no need for it and I thought it looked better any way. Easier to anchor also.
__________________
1986 V20  Old Fishermen never die, we just SMELL that way!!
|
|
#3
04-27-2009, 09:51 AM
|
|||
|
|||
|
These things are a pain in the butt to replace, the two front ones are behind a fiberglass wall where the anchor rope resides. I can't think of anything to but cut the screw heads off with a dremel...
|
|
#5
04-27-2009, 10:30 AM
|
||||
|
||||
|
http://www.discountmarinesupplies.co..._Fittings.html
You might want to check here for replacements...
__________________
'74 V-20/ BF 150 '95 V-21/ BF 150 '84 V-20/ 200 2.4 Merc '87 V-20/'18 F150 Yamaha 
|
|
#6
04-27-2009, 10:54 AM
|
||||
|
||||
|
same here...drilled the tops off when I redid the rail on my Wellcraft bow rider...fortunately the new fittings had hole pattern different from original so it was no problem.
__________________
1986 V-20 1986 Yamaha 150 HP
|
 |
|
|
Linear Mode
