Need some electrical help

[mauryc]

Brought her to the launch today and had a no start. I could only get about .5 volts to the starter and the power trim. Battery is fully charged and everything worked in the driveway about an hour before (tilt/trim and motor started right up.) I'm getting 12.5 volts to the red and black to the switch, but I need a diagram to see which wirea are what for the output. Anything else it could be except the switch? I could see solinoid if it were only the starting issue, but its affecting the tilt/trim also. I did wash her down before I left so maybe I fried the switch?

Thanks,
Maury