|
|
#3
03-26-2008, 06:18 PM
|
|||
|
|||
I installed two s.s. flush mounts that angled back, but not outward. You've got to take into consideration the angle before drilling any holes. I think mine were angled back somewhere around 30*.....soooo you need to bore into your gunnel holding your drill at 30*. It was a little intimidating drilling a 2 1/8" hole right in the center of my gunnel....measure 10 times, make sure you don't interfere w/ rod boxes, steering/ electric wires etc. and you'll be good to go
|
|
|
Threaded Mode