|
|
|
|
#1
|
||||
|
||||
1990 Evinrude tiller handle question
I picked up a 1990 6hp Evinrude tiller the other day. The wiring for the kill switch was ripped out on both ends. I got the wire routed and connected to the motor end just fine. I cannot figure out how to take the tiller handle apart to connect that end of the wire.
Ive attached a picture of the handle, any help would be appreciated. 
__________________
Boatless 
|
|
#2
02-24-2018, 02:43 AM
|
||||
|
||||
I have no idea how to take the handle apart, but I can tell you that a kill switch is a simple thing to wire. Several of my smaller outboards have them mounted in the front lower engine cowl. Rather than take a chance of breaking something expensive in the tiller handle why not just buy a new switch off eBay https://www.ebay.com/itm/Outboard-En...9XD2cl&vxp=mtr, drill the proper size hole in the cowling and install it. Sometimes we over-engineer things when just the simplest of solutions will do the job better.
__________________
1987 V20 w/1987 150HP Yamaha on a Shoreland'r Trailer 1978 16.5 Airslot w/1996 120HP Force on a Four Winns trailer 1996 V21 w/1993 200HP Mercury on a Shoreline Trailer All towed by a 5.7L Hemi Durango. If God didn't have a purpose for us we wouldn't be here, so Live simply, Love generously, Care deeply, Speak kindly. (Leave the rest to God)  Silence, in the face of evil, is itself evil. Not to speak is to speak, not to act is to act. God will not hold us guiltless. Last edited by Destroyer; 02-25-2018 at 02:51 AM.
|
|
#3
02-24-2018, 07:01 AM
|
||||
|
||||
|
Destroyer, I like the way you think
doing what you said has been my plan B all along, since i cant even find a diagram on how to take this thing apart plan B seems like the way to go
__________________
Boatless
|
|
#4
02-26-2018, 10:16 PM
|
||||
|
||||
|
If it's like my 4.5hp, look near the bottom of the actual twist handle and there will be 2 tabs you push in. This allows the handle to slide forward. Be carefull as there is rollers and a pin inside that connect thethrottle cable to the ramp mechanisms. Once the handle is apart, it just basically falls apart in your hands, so be ready to catch pieces.
__________________
2011 SUNDANCE B20CCR SKIFF, 2011 YAMAHA 90HP 4 STROKE, 2011 KARAVAN SINGLE AXLE ALUMINUM TRAILER, LOWRANCE ELITE-7 HDI, MINN KOTA RIPTIDE TROLLING MOTOR 2000CC HYDRA-SPORT 225+HP EVINRUDE SOLD  AND THE PINK JEEP!!!! R.I.P. http://www.wellcraftv20.com/communit...ad.php?t=11664 
|
|
#5
03-01-2018, 12:23 PM
|
||||
|
||||
|
Quote:
Motor is working good now, thanks again
__________________
Boatless
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
