|
|
|
|
#1
|
||||
|
||||
Shaping the sides and nose (all done with a skillsaw)
 Final thickness:  Almost done:  All i have left on actual construction of it is making sure i have a 5 degree bevel on all edges, installing one last threaded rod thru the nose and routing the edges and hole with a roundover bit. Then its teak oil time! 
__________________
1983 V-20 capsized. . . . in the garage. 
|
|
#3
05-05-2008, 09:48 AM
|
|||
|
|||
|
Nice work!
A pulpit for my 250 is on my future project list. I don't think I'll be able to turn out one as nice as yours though. For that matter, I might be challenged to make one as nice as your mock up! I noticed the layout lines on the mockup that show where the raised part of the gunnel will fall. What are you doing to support the pulpit behind that point, where the actual deck is a few inches lower? Steve P.
|
|
#4
05-05-2008, 09:55 AM
|
|||
|
|||
|
Very nice work J. COOP!!!!!
__________________
*************************************** Stay Safe!  Sold - 1984 V-20 Cuddy with a 2003 Johnson 140 hp gas sippin 4-stroke. 1995 Ranger 250C with a 2015 Suzuki 300 hp 4-stroke.
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
