Hatch cover repair.

[Skools Out]

here's where i did the one in my 21


epoxyed in the new 10 ply 3/4 wood for gas tank floor panel.










epoxyed the floor panel's new wood in and them put glass over it to hold in place. then cut in the access hatch for the fuel lines. i hate a floor hatch to stick up and be a toe buster so i took the router and recessed in the floor hatch.









new wood and new glass cloth dried





This is where there had to be a 1/4 inch more spacing for fuel fill





Here's the glass i used for the panel, i shouldn't ever need glass again. This is 42" wide and 250 yard roll. just got plus the other the guy gave too it's 3/8 inch glass in bottom pic heavy heavy crap

[msbhammer]

Good work there SKOOL. ;)

[randlemanboater]

HHHMMMMM, wonder where I could find some glass to use to repair my hatch here in central NC? ::)

[Skools Out]

hum i wonder lol i got that roll free *;D they make it in Gibsonville, NC for boat manufactures. when a roll doesn't roll on straight or runs out before a full spool they toss it out. which then you stop by and asking if they have any bad runs they say sure go out back get what ya want lol *;D

[randlemanboater]

I'll need the address. ;D

[Skools Out]

i'll find it out

[cfelton]

Id like it too ! Fine work there Skools

[Skools Out]

thanks ;D

[msbhammer]

Randleman, when your ready to do the job and need some mat, I can send you down some. I grabbed some big pieces from a yatch the was being rebuilt here in the boat yard.

[randlemanboater]

Originally Posted by MSBHAMMER

Randleman, when your ready to do the job and need some mat, I can send you down some. I grabbed some big pieces from a yatch the was being rebuilt here in the boat yard.

Speaking of which, I got a little package in the mail the other day........Thanks again, I owe you a dozen Choc Covered Kreme Filled. ;D