|
|
#1
|
||||
|
||||
Installing NFB Steering Helm
Hey guys,
I'm to the point where I've removed the old hydraulic steering and have run the new steering cable through the gunwale. * As I was getting ready to install the bezel and the helm, I noticed that the existing hole from the previous helm is too big for the new one. *I have to make the hole smaller. *What should I do? *I know one option would be to glass in the hole with plywood, but would that be smart? *All of the stress from the new helm would be placed right within the patch area. *Should I consider glassing along with a piece of aluminum going across that whole face of that section where the steering wheel goes? * Here's the hole as it exists now: 
__________________
 1990 Hydrasports 2000cc Vector with 96 200HP Oceanrunner. Saved by grace alone, through faith alone, in Christ alone http://www.providencerpchurch.com/ 
|
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode