Holes in transom - Wellcraft V20 Community

03-22-2007, 05:44 PM

Stillrunning Stillrunning is offline

Senior Member

Join Date: Dec 2006

Location: Suffolk, Va.

Posts: 972

Re: Holes in transom

Take a drill bit and ream them out just a little to clean out any caulk or other stuff. I then would get that stuff made by West System which is a white powder which thickens up resin and will add strength. Tape over one side of hole and fill. May take a couple of times to get it nice and smooth.

« Previous Thread | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Forum Rules

All times are GMT -5. The time now is 10:24 PM.