Decals????

[lumberslinger178]

listen to these guys there all rite I did the name decals on all my boats its really easy ;D

[C YENSEN]

thanks boys, and Stillrunnin, they are really good decals, look on ebay under "wellcraft". I think the name of the seller was "taylorint" or something, he always has them for sale on their.

[msbhammer]

Been looking at a few myself CY. See some nice one's on E-Bay. I'll get to it around spring time. Even though today was quite a warm day. 8)

[Stillrunning]

I've seen the one's on ebay and was worried about quality so thanks for the help. If you don't mind me asking what did you pay for yours because I have seen different prices and was it the same size as the old decal? I am also looking for the black SPORTSFISHER sticker but have had no luck.

[Stillrunning]

Originally Posted by Skools Out

clean surface with as about but then install with soapy water. mix dish soap in spary bottle with water just a little bit of soap. then spray on the location you wish stick to be and peel back apply on the soapy area then slide it around till you like the placement and use a bondo paddle to squeegy the soapy water away from the decal getting all the air bubbles out *but once you do this the decal is there to stay so have it right before you do the squeegy,

I was going mention the soap thing but was not sure if you could use soap on all decals.

[Skools Out]

yeah it's great i tested it on even my bumper stickers plus the season ramp pass decals worked great.

[LESTERUS]

CY: ONE WORD OF ADVISE, DO NOT APPLY THEM ON A DRY HULL, WET THE AREA WHERE YOU'RE GOING TO STICK IT, THAT WOULD ALLOW YOU TO CENTER IT, THEN GET A 6" PLASTIC SPATULA AND GO OVER IT SOFTLY TO MAKE SURE YOU GET ANY AIR BUBBLE OUT, LET IT DRY A LITTLE AND FINALLY TAKE THE OUTER SHEET.

NOTE: I HAVE A PRINT SHOP NEXT DOOR AND THAT'S HOW THEY DO IT.

REGARDS,LESTERUS

[C YENSEN]

Originally Posted by LESTERUS

CY: *ONE WORD OF ADVISE, DO NOT APPLY THEM ON A DRY HULL, WET THE AREA WHERE YOU'RE GOING TO STICK IT, THAT WOULD ALLOW YOU TO CENTER IT, THEN GET A 6" PLASTIC SPATULA AND GO OVER IT SOFTLY TO MAKE SURE YOU GET ANY AIR BUBBLE OUT, LET IT DRY A LITTLE AND FINALLY TAKE THE OUTER SHEET.

NOTE: I HAVE A PRINT SHOP NEXT DOOR AND THAT'S HOW THEY DO IT.

REGARDS,LESTERUS

thanks man ;D