![]() |
|
|
|
#1
|
||||
|
||||
|
well more wiring done tonight and worked on the Evinrude 225 i picked up over Easter.
__________________
1978 V20 Cuddy w/ 225 Johnson. And Several other boat's |
|
#2
|
|||
|
|||
|
What no pics of the Rudey being taken apart. ;D
You ship me out my seats yet. ;D
__________________
|
|
#3
|
||||
|
||||
|
what you mean like MJ :'( every one is picking on me :'(
__________________
1986 V20 ![]() Old Fishermen never die, we just SMELL that way!! |
|
#4
|
||||
|
||||
|
It's ok MJ your wiring is ok if you like spaghetti ;D Well did more work today and have pics will post later tonight
__________________
1978 V20 Cuddy w/ 225 Johnson. And Several other boat's |
|
#5
|
||||
|
||||
|
Well today after all wiring and other stuff i decided to install a new lanyard in the boat since it had never had one i thought it would be a nice addition. Here's the dash after all mounted.
![]() ![]() Here's the back of the ign. switch and control panel. The white net has the warning horn inside it. ![]() ![]() ![]() Here's the plugs i ordered from Jameco.com one is to connect the motor harness and the other is for the boat harness to the fuse panel. ![]() ![]() Here's the fuse panel wired ![]() Here's the 2 lower gauges fuel and voltage.
__________________
1978 V20 Cuddy w/ 225 Johnson. And Several other boat's |
|
#6
|
|||
|
|||
|
nice work skools. That is one area where I do NOT excel, wiring and wiring diagnosis.....yuk.....why is the warning alarm wrapped in that mesh stuff?
|
|
#7
|
||||
|
||||
|
wrapped up to protect the main wiring harness from it's weight in one spot and to keep out direct water spray.
THanks i hope it looks good to you guys i strapped up all the wiring with c clips for low voltage wiring, i know the pics are hard to know where it's looking but i was under the dash taking the pics.
__________________
1978 V20 Cuddy w/ 225 Johnson. And Several other boat's |
|
#8
|
|||
|
|||
|
Glad to see ya back at work with her. Looking good there SKOOL. ;D
__________________
|
|
#9
|
||||
|
||||
|
pictures for Hammer lol this is the 1990 motor i picked up over Easter. What ya think i only gave $50 for it, 225 Evinrude 25" shaft.
![]() ![]() ![]() ![]() ![]() ![]() Took off the heads to look at the salt and to my shock very little, the compression is 90 psi on all but 1 it has 80 so i took the head on this side first and found cylinder has some scoring, i'm going to re-ring her any way then. The marina said it was scrap and they had sold the power pack off due to bad flywheel, all it needed was magnets re-glued, dummies lol.
__________________
1978 V20 Cuddy w/ 225 Johnson. And Several other boat's |
|
#10
|
|||
|
|||
|
hey skools, did you pick that up when you were on L.I. ??
|
![]() |
| Thread Tools | |
| Display Modes | |
|
|