Checking stator

[Dana A]

Originally Posted by steplift20

150 1988 Mercury out board, I had a problem with my engine and I am going to change my 2 switch boxes but I want to check my stator, my question is this, I have the batterys out of the boat do I have to install my battery to do the test? I know it has to be grounded to the engine and turned off but do I have to put the batterys in. Can it be tested with the batterys out.

Good video of checking stator
https://www.youtube.com/watch?v=zlxIyOa_DkA

[spareparts]

stator outputs should be checked while spinning the engine over using a DVA adaptor hooked to a volt meter. But you can check stator resistance using an ohm meter

[steplift20]

Thanks for the info, I watched the YouTube video and helps me a lot , I will post how I make out . Thanks