|
|
|
|
#1
|
|||
|
|||
It is cracked and falling apart. If I took it out I would just have a hole there. I would prefer not to replace with a hatch. I cant believe it is soo hard to find a replacement part where you still retain room for your feet.
|
|
#2
04-18-2020, 10:54 AM
|
||||
|
||||
|
the biggest problem with the rod boxes were the flanges where they were screwed to the inner liner. mine were all cracked and falling apart. to remedy this , I glassed a strip of fiberglass tape around the edge. didn't really matter what it looked like because it was on the inside.
only other thing I could suggest would be cut the hole square & build something out of starboard,  
|
|
#3
04-26-2021, 09:47 PM
|
|||
|
|||
|
Have you fixed this yet? Pull the old one and make a plug from the original. If this is beyond your ability, find a local fiberglass shop to do that.
Of course if the original is glass then just repair it.
__________________
FL Bill 1988 Wellcraft 20 Sportfisher
|
|
#4
04-29-2021, 12:53 PM
|
||||
|
||||
|
if its the same plastic they use in the rod boxes, poly resin bonds pretty good. sure an epoxy would too.
I did the back if the rod boxes with 1.5oz matt and at 225lbs I can stand on them, supported me and no separation. I actually took one and threw is across the shop to see if the plastic would separate or plastic would crack - all good IMG_5683.jpg
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
