![]() |
|
|
|
#1
|
|||
|
|||
|
Thanks, Tommydoe
Does yours also have the 2-wood hatches in front of engine cover, that go straight into bilge? are they also supposed to have liners? Storage I guess? Should mine have had a Back to Back, lounge seat on the Port side from factory? PO has install 2- swivel seats on pedestals. (back to back) Any guess on fuel tank capacity? It does have SINGLE tank as I can see only ONE fill on starboard side, deck has 2- pry-out covers in floor.
__________________
1979 Wellcraft V20 , I/O, Cuddy 1982 SeaRay 260 Express Cruiser (SOLD) 1976 Aquasport 19.6 Family Fisherman, O/B (SOLD) |
|
#2
|
|||
|
|||
|
I have the same compartment but mine has teak like the swim platform. I use mine for batt compartment . Put brace down then star board with site hole to make sure she stays dry . I have 2 27 ser deep cycle in there still room for tackle box & ropes
|
|
#3
|
|||
|
|||
|
I see that your motor box is like mine, held down by "Gravity". no latches?
really like your 2 side seats, . wish Mine had that...were they a option?
__________________
1979 Wellcraft V20 , I/O, Cuddy 1982 SeaRay 260 Express Cruiser (SOLD) 1976 Aquasport 19.6 Family Fisherman, O/B (SOLD) |
|
#4
|
|||
|
|||
|
I meant to put some type of latch on but seats hold tight. I made mine out of old back to back seat i found on cg list. They sell jumper seats but the red ones where the original one's on port side the bottom was rooted so i took the best of the 2 i got on crags & cut the base apart on the other . I didn't mount the back ones so i can move more room to fish .
|
|
#5
|
|||
|
|||
|
Oh they were not an option as far as i know but i saw what other people did & liked the idea i have 2 kids so needed seats . Half my friends have cussed me out they think takes up room to fish but they don't have children so another reason for not mountain.
|
![]() |
| Thread Tools | |
| Display Modes | |
|
|