![]() |
|
|
|
#1
|
|||
|
|||
|
I have some photos of the "Transom Boxes" , that I'm asking about.
The lift out boxes , are plywood, not sure if original but fill up with rain water and have NO drains. Is that Factory? They have to be removable to gain access to battery and trim pump. and all the wiring back there......
__________________
1979 Wellcraft V20 , I/O, Cuddy 1982 SeaRay 260 Express Cruiser (SOLD) 1976 Aquasport 19.6 Family Fisherman, O/B (SOLD) |
|
#2
|
|||
|
|||
|
Ive seen pic the factory ones were plastic not many survived yours are home made .i dont have anything in mine yet i just use to vent. Makes nice seat to seat on with feet in water on platform
|
|
#3
|
|||
|
|||
|
Thanks, Tommydoe
Does yours also have the 2-wood hatches in front of engine cover, that go straight into bilge? are they also supposed to have liners? Storage I guess? Should mine have had a Back to Back, lounge seat on the Port side from factory? PO has install 2- swivel seats on pedestals. (back to back) Any guess on fuel tank capacity? It does have SINGLE tank as I can see only ONE fill on starboard side, deck has 2- pry-out covers in floor.
__________________
1979 Wellcraft V20 , I/O, Cuddy 1982 SeaRay 260 Express Cruiser (SOLD) 1976 Aquasport 19.6 Family Fisherman, O/B (SOLD) |
|
#4
|
|||
|
|||
|
I have the same compartment but mine has teak like the swim platform. I use mine for batt compartment . Put brace down then star board with site hole to make sure she stays dry . I have 2 27 ser deep cycle in there still room for tackle box & ropes
|
|
#5
|
|||
|
|||
|
I see that your motor box is like mine, held down by "Gravity". no latches?
really like your 2 side seats, . wish Mine had that...were they a option?
__________________
1979 Wellcraft V20 , I/O, Cuddy 1982 SeaRay 260 Express Cruiser (SOLD) 1976 Aquasport 19.6 Family Fisherman, O/B (SOLD) |
|
#6
|
|||
|
|||
|
I meant to put some type of latch on but seats hold tight. I made mine out of old back to back seat i found on cg list. They sell jumper seats but the red ones where the original one's on port side the bottom was rooted so i took the best of the 2 i got on crags & cut the base apart on the other . I didn't mount the back ones so i can move more room to fish .
|
|
#7
|
|||
|
|||
|
Oh they were not an option as far as i know but i saw what other people did & liked the idea i have 2 kids so needed seats . Half my friends have cussed me out they think takes up room to fish but they don't have children so another reason for not mountain.
|
![]() |
| Thread Tools | |
| Display Modes | |
|
|