|
|
|
|
#1
|
|||
|
|||
So I called the local repair shop and they have the relays in stock. I'll swing by tomorrow after work and see if that doesn't solve my problem. I would have gone earlier in the week but the weather hasn't been cooperative. If not I guess I'll have to try your advice Destroyer. By the was it's a 2000 Evinrude Ocean Pro 200 hp. And yes, I did retighten the manual release screw.
|
|
#3
06-03-2017, 01:19 PM
|
|||
|
|||
|
So I finally got the trim relays I needed and the weather is cooperating. The good news is it got the motor moving. The bad news is it's only moving a few inches before stopping. I can hear what sounds like a bubbling noise when I hit the up or down button. After watching a dozen YouTube videos I'm fairly certain I bled the air properly. Are there any seals or gaskets I should be inspecting to see if they have failed? I've never owned a boat with power trim before so this is uncharted territory for me. I'm really hoping I don't need to replace the whole assembly. Also, the motor is a 1994, not 2000 as I previously stated. Not sure where that came from...
|
|
#4
06-03-2017, 05:04 PM
|
||||
|
||||
|
On my 98 I had the same issue. It turned out to be a bad wire on the limit switch. I replaced the section and it works.
__________________
1999 Wellcraft 22WA-200 Ocean Runner 1982 Grady White Tarpon 190-110 Evinrude-Sold 1996 Striper 2100WA-RIP Sandy 1989 Wellcraft 18-Sport-125 Force-sold
|
|
#5
06-03-2017, 08:16 PM
|
|||
|
|||
|
Upon further inspection I noticed that there are two wires that go from the motor to the trim motor, a blue one and a green one. The blue one has been smashed almost flat where it enters the trim motor. I borrowed a voltmeter tonight and will check tomorrow to ensure there is enough power going to the trim motor. That'll be a $200+ fix if it's the problem.
|
|
#6
06-03-2017, 08:19 PM
|
||||
|
||||
|
Maybe you can disassemble the motor and repair the wire.
__________________
1999 Wellcraft 22WA-200 Ocean Runner 1982 Grady White Tarpon 190-110 Evinrude-Sold 1996 Striper 2100WA-RIP Sandy 1989 Wellcraft 18-Sport-125 Force-sold
|
|
#7
06-03-2017, 08:26 PM
|
||||
|
||||
|
Should be able to put 12vt to those wires and make motor go up and down, this will eliminate all variables upstream of motor.
Hot wire to one at a time, unit grounds through the frame, hope that makes sense. One damaged wire is going to give you loss of one function.
|
|
#8
06-03-2017, 08:28 PM
|
|||
|
|||
|
I thought about that but unless I can take the cover off the motor I don't think it's going to happen. There's just not enough slack to cut and splice.
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
