Seat Boxes

[mawshj]

I will be looking to replace my lounge passenger seat this summer. V20 cuddie 1983. several (maybe 2 I have found) make replacements. (high storage base with snap close flap)(larger then most seat dimensions)(pull out to lounge position)(rot proof frame). I am not sure what your seat box is but I would certainly take a look at it

[livnontheriver]

is he making the seat insert in the center console?

[spareparts]

The guy who may be building these is the guy whos making the small skiffs I posted up a while back. Were trying to get some measurements to see if we could be able to adapt an existing mold to work. Don;t have a price yet, I'll be the test subject on this one

[Blue_Runner]

Just measured it.

39" long x roughly 21" wide x 12" tall. I say roughly cause I measured the front at 21 1/4 and the back was like 20 3/4.

I think it is a bit funny they didn't just go 40" long. Could've used that extra inch a time or two on the fish box side.

[spareparts]

thanks

[Troutkiller2006]

Originally Posted by Blue_Runner

Just measured it.

39" long x roughly 21" wide x 12" tall. I say roughly cause I measured the front at 21 1/4 and the back was like 20 3/4.

I think it is a bit funny they didn't just go 40" long. Could've used that extra inch a time or two on the fish box side.

lets be honest, who couldnt use an extra inch

[mushman]

Can you post pic of the finished seatbox when done?. I would be interested if price is decent.

[spareparts]

working on the plug. Estimated cost is going to be around $250-$300 per box. You will have to trim it to fit the angle of the cockpit floor. It will be square(measurement wise) so you can use it on either side or mount it in the center behind a console. It will have a wood backed top for reinforcment. When we get a prototype done, i'll post up some pictures