update on my 3.7

[smokeonthewater]

Actually you DID say "clean up" and I knew what you meant.
I've seen it go both ways ..... Both with a "well known" fellow doing the work.
As long as he really does have a good understanding of what works well for a marine engine you are likely ok but sooo many people want to build a boat engine the same way they would a dragster. Just saying be careful mate.

[aussie]

Originally Posted by smokeonthewater

Actually you DID say "clean up" and I knew what you meant.
I've seen it go both ways ..... Both with a "well known" fellow doing the work.
As long as he really does have a good understanding of what works well for a marine engine you are likely ok but sooo many people want to build a boat engine the same way they would a dragster. Just saying be careful mate.

I don't really want a race boat I need good idle and bottom end to get the boat on the plain with my wifes fat *** in there
lol really I want a good idle don't want it thumping when I engage it into gear or doing 5mph at idle

[smokeonthewater]

personally I'd most likely leave it alone.. edelbrock makes good stuff right out of the box... MIGHT be worth a call to edelbrock tech line to discuss their thoughts on your planned mods tho

[aussie]

IM BACK 4 WEEKS LATER AND STILL NO CONRODS SUMMIT WHAT YOU DOING TO ME CANT TAKE 4 WEEKS TO SHIPPED THEM ACROSS THE STATE

[aussie]

got the pistons back and they have been coated happy there blue not chevy orange lol

[aussie]

Went and seen my mate at the machine shop and he hasn't done anything to the engine since I dropped the connecting rods off. He told me in 4 weeks and I said I need it now as its too close to summer know and I want to wet it this year

Finally bought some head studs found them on ebay Jeggs has a ebay store . Well I had dramas with that buy too .they said they post internaion and they needed to give me a price. Four weeks I remined them every week no reply so I just bought another set of them and then they woke up . I bought them of ebay because they were the only ones that would sell a set for one head . The studs ended up coming and when I went to collect them the package seemed heavy . when I got home and open it sure enough they sent me 2 head sets not one . I should sell these on ebay and then buy another 1/2 set and keep doing it till they wake up LOL

[aussie]

I have got a 500 cfm edelbrock carb that I bought for my engine .I was thinking of buying a 750 cfm edelbrock as well as I think when the boat is on the cruise it may have the secondaires on the carb open beacause the primary ones are small . I have had this on cars too were a bigger carb in a 4 barrel gives you better millage ???? WHAT ARE YOUR THOUGHTS