Electronic fuel pump on Carb Motor

[nymack66]

Install the fuel pump, I notice it is not exceeding 2 PSI? I bypass the motor and use it to pump all the old fuel from the tank looks like STA-BIL did its job, some curd and water was noticeable however.
I replace the fuel filter also, I will fuel her up with fresh fuel 50:1, spray some sea foam carb cleaner directly into the open carbs and bump the key. Stay tune :)

Current configuration TANK>Fuel/Water Separator Filter>Fuel Pump>Regulator>Primer Bulb>Carbs

[nymack66]

Oh how sweet it is to bump the key and she starts right on, I like to call it an ETEC start minus the cost. I still ask myself why I did not do this a long time ago. Basically I turn my ignition key on wait 10 seconds, press key in once release turn, honestly after the second turn on the switch she started up after 2 years no carb cleaning unbelievable. I will now heed advice and install a red Holley and keep this pump as spare ready to go with little field modification.