![]() |
|
|
|
#1
|
||||
|
||||
|
yeah that o-ring at the top is a good thing, i've had one stuck too. had to cut the drive shaft then remove the power head and heat then pry the shaft out of the power head...
__________________
1978 V20 Cuddy w/ 225 Johnson. And Several other boat's |
|
#2
|
||||
|
||||
|
did you get the boat fixe---is there a happy ending---
|
|
#3
|
||||
|
||||
|
I did this to one before. The driveshaft was stuck so tight I ended up welding a flange to the cut off shaft so I could use a 5 pound slide hammer on it. After 2 hours with the torch and slide hammer it finally gave up. Cleaned up nice with a barrel brush.
__________________
2011 SUNDANCE B20CCR SKIFF, 2011 YAMAHA 90HP 4 STROKE, 2011 KARAVAN SINGLE AXLE ALUMINUM TRAILER, LOWRANCE ELITE-7 HDI, MINN KOTA RIPTIDE TROLLING MOTOR 2000CC HYDRA-SPORT 225+HP EVINRUDE SOLD ![]() AND THE PINK JEEP!!!! R.I.P. http://www.wellcraftv20.com/communit...ad.php?t=11664 |
|
#4
|
|||
|
|||
|
if I'm correct that 1996 pee hole removes so you can screw a hose in to flush the motor. Just take it off and see if its clogged.
|
![]() |
| Thread Tools | |
| Display Modes | |
|
|