what to use to cut fiberglass

[Destroyer]

Originally Posted by spareparts

I guy I used to know up in NC used to build wood boats(biggest ones was 72'). When he fitted the planking to the keel, he would cut a grove for the planking to fit in. He had an old 10" angle grinder with a 10" carbide table saw blade(no guard) in it to make the cut, he said if it ever felt like it was going to catch on something, he's just throw it away from himself and let it hit the ground. He called it his bob cat. Surprisingly, when they buried him(stroke), he still had all his fingers

OMG!!!

[wellcraftv20step]

i have the Milwaukee brand multi tool, I use that thing more than any other tool in my truck. Great for cutting shims on a cabinet installation, rgeat for notching studs to burry a wire, cutting back floor base molding when installing the case molding on a door, cutting outlet boxes into the cabinet over the microwave. chamfering moldings. notching the quarter inch reveal on a top hanger cabinet to accept crown molding , square holes in sheet rock for repair,cutting door frames to slip laminate flooring under it. I even used it once to notch hinges in a door when my router broke. i dont know what i did without that tool for so many years. oh and the best part is no dust !. this week i will try it widen the hole for my new switch panel.