Va Beach v20 project

[kamikaze]

Kracker:

I recommend you dry your rigging thru that chase before you mount the deck. It looks relatively small in the pics with several 90 degree corners that may makes rigging a real pain. Especially if your going to use mechanical steering!

Keep up the good work.

Kamikaze

[Kracker Jack]

Originally Posted by kamikaze

Kracker:

I recommend you dry your rigging thru that chase before you mount the deck. It looks relatively small in the pics with several 90 degree corners that may makes rigging a real pain. Especially if your going to use mechanical steering!

Keep up the good work.

Kamikaze

You are on point! I tried it today and its a no go. I'm going to run the teleflex and controls another route and just keep that Chase pipe for power and neg wires ,fuel and other wiring. I'm just not comfortable cutting my stringer out any more.

[reelapeelin]

Originally Posted by Kracker Jack

You are on point! I tried it today and its a no go. I'm going to run the teleflex and controls another route and just keep that Chase pipe for power and neg wires ,fuel and other wiring. I'm just not comfortable cutting my stringer out any more.

I noticed that pipe...was thinking instead of a single 90* elbow under the console, two 45s would make a much easier pull of it...I would think the steering cable would go thru that...

[Kracker Jack]

The transom end is 2 sweeps together to make a broad 90 degree angle.The other ened was just a hope and a prayer. It really not to big of a deal beacause I have a plan B to run teleflex and controls

[RidgeRunner]

Your work is great. I used a 4" chase but kept it inboard of the stringer, actually lays on top of the fuel tank in my center console.

[Kracker Jack]

Originally Posted by RidgeRunner

Your work is great. I used a 4" chase but kept it inboard of the stringer, actually lays on top of the fuel tank in my center console.

Ridge thanks for the compliments. I thought about running the Chase down the middle but I had to end up running the teleflex outboard of the stringer sooner or later to get the bend to attach to motor. The way I'm running it now allows the teleflex and controls to kinda relax alittle better.

[Blue_Runner]

Looking good Matt!