|
|
|
|
#1
|
|||
|
|||
hey
looking good i have mine all the way apart taking top off tomorrow and begin demolition i have pics just trying to figure out how to get them from my phone straight to here
__________________
77 v20 cuddy cabin chevy straightsix 
|
|
#2
12-17-2011, 07:15 PM
|
||||
|
||||
|
I take pics with my phone and then send them to my email. After they show up on my email I then download them to my computer. After that i go to my thread and open up the comment or reply to thread window. Then click on that paper clip icon on the tool bar next to the smiley face. your picture download window will then open. Click browes and your commputer options for pictures window will open double click your picture of choice.click up load on your picture download window and your done. Did I explain that right Last edited by Kracker Jack; 12-17-2011 at 07:21 PM.
|
|
#4
12-18-2011, 06:19 PM
|
||||
|
||||
|
Here are some pics from yesterday. I set the stringers up yesterday and glued them today. Notice on my inner skin on my transom the dark color glass in the middle where the motor mounts, thats because a guy off the HULL TRUTH recomended me to put that 2 layer of 1708 patch there for load purposes. I still have one more layer of 1708 to put on the transom but im gonna wait till I glass the stringers to the transom first so the last layer of 1708 kinda locks the stringer tabs in. The last picture is of the resin soaked dowels I put through my all-thread holes that I used to clamp my plywood. My next step is to glue and screw my stringer cleats on then glass in my stringers!!!!! fun fun fun!!!
|
|
#5
12-18-2011, 08:16 PM
|
|||
|
|||
|
stringer question
on your old stringers were they straight to the outer shell mine were an a sixteenth to an eighth off the shell so far im stuck on what to do about the two boxes and getting them out
 looking good 
__________________
77 v20 cuddy cabin chevy straightsix
|
|
#6
12-18-2011, 09:16 PM
|
||||
|
||||
|
Pic of bedded and glued stringers, And pic of cap getting prepped for lamination of 3/4 inch ply on top of existing 1/2 inch. I want to beef up the cap a little more.
Last edited by Kracker Jack; 12-18-2011 at 10:04 PM.
|
|
#7
12-19-2011, 10:39 AM
|
|||
|
|||
|
Keep up the good work
Kracker:
Can't see in your lastest pics, but I assume you have weep holes aft to allow and water to drain the the garboard plug? It also looks like your center stringer aft 90 is solid. You might want to notch the corner so water can drain from either side "JUST IN CASE" Keep up the good work! Kamikaze
__________________
 74 V20 CC with a 150 Johnson (Gone but not forgotten) 89 V20 Cutty with a Tower (Build in process)
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
